Monte Carlo Fan Company 4AAR13XXD Series, Owner'S Manual And Installation Manual

Page: 4 / 9

4
© 2011 Monte Carlo Fan Company
1/20/2012
7 8 9
10 11
Set dip switches on the Remote
Transmitter and Remote Receiver to the
same settings. This must be done so the
units will communicate properly. If you
have other fans you can set to control
from one Transmitter by setting
receivers the same as the Transmitter. If
you have more than one fan with remote,
you can set the dip switches to different
positions to have separate control.
Make wiring connections using wire
connectors provided as indicated above.
White from fan to white from remote
marked N. Blue from fan to blue from
remote marked light. Black from fan to
Black from remote marked L. White from
house to white from remote marked AC
N. Black from house to Black from
remote marked AC L. Connect all green
grounded wires to Grounded wire from
House. Make sure that no filaments are
outside of the wirenuts.
Insert the remote receiver into mounting
bracket.
Loosen one and remove one
preassembled canopy mounting screw
from mounting bracket. Save canopy
mounting screw. Lift canopy up, aligning
its keyhole slot with the preassembled
screws on mounting bracket and twist
clockwise to lock in place. Re-install the
removed canopy mounting screw and
tighten all screws securely.
Attach canopy bottom cap onto canopy
by aligning its notches with the
preassembled canopy mounting screws
on mounting bracket and twist clockwise
until tight.
Install 3 x 40 watt candelabra base bulbs.
Bulb included. Attach glass to light pan by
locating dimples in light pan with grooves
in glass and twist clockwise until tight.
WARNING : Over lamping the fan will
result in the fan lights shutting down until
the proper wattage of bulbs are installed.
Reset the lights by turning off, replace
bulbs with the correct wattage bulbs, turn
the power on.
Note : Do not replace bulb until it cools
down.
Note : Go to step 12 if you want to install
the fan without light
Loosen the knob by turning
counterclockwise (as arrow shown) for
the fan angle adjusting. Fasten the knob
when the fan is in position.
It can be adjusted with 5 different angles
and the fans at both sides can be
adjusted at different angles.
ON
Dip switches
Wall switch
Black
White
Ground/Green
Ground/Green
White
White
Blue
Black
Black
For fan with light, go to
step 10.
For fan without light, go to
step 12.
arrow
Knob