Control Element
- 6 -
REAR PANEL
1-
Channel A Link out
2-
Channel A XLR/TRS Input
This XLR/TRS jack will accept any balanced or unbalanced low impedance line level source
by means of a three-pin XLR/TRS plug.
The wiring for
the plug is as follows:
Pin1(Sleeve)=Ground, Pin2(TIP)=, Pin3(Ring)=Signal-.
3-
Channel B TRS/XLR Input
This XLR/TRS jack will accept any balanced or unbalanced low impedance line level source
by means of a three-pin XLR/TRS plug. The wiring for
the plug is as follows:
Pin1(Sleeve)=Ground, Pin2(TIP)=, Pin3(Ring)=Signal-.
4-
Channel B Link out
5-
SUB-X-OVER FREQ
Cut off frequency selectors for low-pass (SUB) filters, the value can be set from 50Hz to
250Hz.
X-OVER FREQ is available in Mode 4(SUB-Stereo) only.
6- MODE
Mode 1: CHA/CHB stereo
Input and output channels are independent.
Mode 2: CHA/CHB parallel
Outputs are the same with any channel input.
Mode 3: NC - Not used
Mode 4: CHA/CHB sub-Stereo
CHA and CHB are stereo,output signal is low frequency, X-over FREQ
CHA/CHB is available.
1
2
3
4
7
8
9
6
5
LION SERIES
LION SERIES
- 11 -
Cablaggi
Fermacavo
Sleeve Tip
Ring
Sleeve=Massa/Schermatura
Ring=Segnale Destro
Tip=Segnale Sinistro
Utilizzare con le cuffie
Connettore da 1/4" Stereo (TRS)
Fermacavo
Sleeve Tip
Sleeve=Massa/Schermatura
Tip=Segnale
Utilizzare con Line In e jack da 1/4" Mono
Connettore da 1/4" Mono (TS)
Fermacavo
Sleeve Tip
Ring
Sleeve=Massa/Schermatura
Ring=Segnale Ritorno
Tip=Segnale Send
Utilizzare per Insert Point
Connettore da1/4" Stereo (TRS)
2=Hot(+)
3=Cold(-)
1=Massa/Schermatura
(vista lato saldatura)
Si usa per Ingressi Mic bilanciati
(Per uso sbilanciato, collegare il pin 1 al 3)
Connettore Maschio 3 pin XLR
2=Hot(+)
3=Cold(-)
1=Massa/Schermatura
Si usa per l’uscita Main
(Per uso sbilanciato, lasciare il pin 3 scollegato)
Connettore Line 3 pin XLR
(vista lato saldatura)
1
2
3
1
2
3
