Owner’s manual
|
REBEL
10
powER suppLY
AC mains switch
This switch allows you to turn on/off the mains a.c..
In “1” position your Rebel is ON, while in “0” position your Rebel is OFF.
Before turning ON or OFF the unit, please be sure that MASTER knob is in “0” position.
Even when using your REBEL with a.c. power, the DC switch must be in “1” position.
Please note that any time your REBEL is connected to mains, despite this switch position, the internal battery is recharged.
DC battery switch
This switch allows you to turn on the internal battery; it’s very useful to avoid wasting your battery life.
In “1” position your Rebel is ON, while in “0” position your Rebel is OFF.
During battery operation, always check the BATTERY LEVEL LEDs.
100 ÷ 230 V ~ 50/60Hz - F 2A L 250V socket
It’s a standard IEC power receptacle, which contains also a fuse-holder.
This fuse holder contains a standard fuse, which is used to protect the unit from damages.
If the unit is connected to power supply and AC and/or DC switches are in “1” position, but the unit doesn’t work, please check the
fuse status.
If you find that the fuse is blown, you must replace it with an identical fuse.
BATTERY LEVEL LEDs
This 5-LEDs section shows you the way your Rebel built-in battery is working.
LEDs 3 - 2 - 1 are green, and are lit when the battery is charge. LOW LED is red, warning you about battery low power.
Orange CHARGE LED is lit when the built-in battery is charging, the LED is unlit when the battery is totally charged.
VEntILatIon poRts
Ventilation slots
NEVER block these slots, otherwise internal power amp could be damaged by internally developed overheat, despite internal fan.
FRont panEL spEaKERs
25.4 mm compression driver
This 25,4mm (1”) driver has a 25,4mm (1”) exit directly connected to the horn to diffuse the sound, covering a wide angle.
205mm (8”) woofer
This custom high excursion woofer develops high sound pressure levels.
Dual leveling feet
This system allows a 17° maximum tilt angle
21
22
23
24
25
27
26
28
