11
MAINTENANCE
CLEANING BURNER VENTURI
1. Remove top panel.
2. Remove right control panel.
3. Disconnect injector fitting and remove.
4. Loosen thumb screw and slide venturi out of the burner head.
5. Clean the venturi in hot soapy water with a stiff brush.
6. Rinse and shake well to remove any debris.
7. Reassemble in reverse order.
CLEANING PILOT BURNER
1. Disconnect the pilot gas supply tubing from the pilot.
2. Remove the pilot injector.
3. Clean by blowing through or washing. Do not use wire to clear the pilot injector.
4. Reassemble in the reverse order.
MISCELLANEOUS
1. Wire brush the surface of the grid to remove baked on material, wash with hot water, dry
thoroughly and reassemble.
2. Clean out the grease container and wash with soapy hot water. Dry thoroughly.
3. Wipe exposed cleanable surfaces with a mild detergent and hot water. Stubborn residue may
be removed with a lightweight non-metallic scouring pad. Stainless steel areas should be
washed with mild detergent, hot water and a soft cloth. If necessary to use a non-metallic
scouring pad always rub in the direction of the grain in the metal to prevent scratching. NEVER
USE STEEL WOOL.
4. Check the operation of the thermocouple and flame safety devise by lighting the pilot and then
blowing it out. Listen for the flame failure valve clicking closed. This action must occur within 60
seconds of extinguishing the pilot.