MONSTERMOUNT MB-3105, Installation Instructions Manual, Page: 6 / 16

ENG
6
5. Place the opened mount arms over the back of your display so that the
hinges are located toward the bottom of the display. Slide each mount along
the length of the tilt adjustment rod until it is lined up with the mounting holes
on back of your display.
6. Attach the mount arms to the back of your display using the screws identied
in steps 1 and 2 (see Fig. 7):
a) If you are using the M6 screws you will also need to use the M6 washers
(H). M8 screws do not require washers.
b) If you are using the longer screws on a display with a curved or recessed
back, you may also need to use the spacers (I). Use one spacer or two spac-
ers stacked as needed.
Only use a spacer if necessary.
7. Close the mount arms by returning them to the original position. Insert the
pin and replace the clip on both arms. Make sure the tilt adjustment rod is
turned to the locked position by rotating the knobs away from the display.
The
mount arms must be fully closed and locked before moving on to the
next part.
For displays
with flat backs. For displays
with curved or
recessed backs. Fig. 7