Step 3
The Interface Cable from the iCruze
®
box
(steps 1-3) plugs into the “OEM Interface”
port on iCruze with the rectangular
or Molex
®
end, while the other round
end goes directly into the Interface
Module IM-NIS1. Make sure to leave
the yellow wire handy for Step 4.
Step 3a
The blue with white stripe wire goes
between both ends of the cable.
In the middle is a connector that comes
apart. Pull the ends to disconnect them.
The female end is not used and can
be left alone.
Step 3b
Cut off the male ‘bullet’ end
and connect this to 12 volt
accessory power.
Step 4
WARNING:
DO NOT ATTEMPT TO MAKE THIS CONNECTION UNLESS
YOU HAVE THE EXPERIENCE AND KNOWLEDGE TO DO SO.
INCORRECT CONNECTIONS MAY CAUSE MALFUNCTION
OF CAR STEREO AND OTHER ELECTRICAL SYSTEM COMPONENTS.
CONSULT AN MECP CERTIFIED INSTALLER
IF YOU DO NOT HAVE THE TOOLS OR KNOWLEDGE
TO MAKE THIS CONNECTION.
The Interface Cable in the Interface Module IM-NIS1 package has
a pair of wires outside of the black jacketing. The yellow wire needs
12 volts constant power just like the yellow wire on the Interface
Cable from the iCruze
®
package. You may join the two yellow wires
together and tap the same 12 volt power source you found in Step 2.
Connect the yellow wires to constant power.
Step 5
The red wire needs accessory
power. You may source this
from the factory stereo harness.
Connect the red wire
to the accessory power.
Step 3
Yellow Wire
Connects
to 12 volt
Constant
Step 3a
Step 3b
Yellow Wire
Connects
to 12 volt
Constant
Blue/White
Wire Connects
to 12 volt
Accessory
IM-FD1
Step 5
Red Wire to
Accessory Power
Yellow Wire
Connects to
12 volt Constant
