INCLUSION
Now that the plugin is in its final location, it can be "included" into the network. Bring
your Z-Wave Interface Controller to the Plugin's location. The distance between the
controller and the plugin should be less than 1 meter during the "inclusion" process.
1. Following the instructions that came with your Z-Wave Controller, set it to
"include" mode.
2. When prompted, press and hold the Program Switch on the plugin for about 1
second.
EXCLUSION
If you wish to remove the plugin from your network, you will need to "exclude" it.
1. Following the instructions that came with your Z-Wave Controller, put the
controller in "exclude" mode.
2. When prompted, press and hold the Program Switch on the plugin for about 1
second to complete the "exclusion".
PROTECTION FUNCTION
The Protection function allows you to control whether the Program Switch is functional
or not.
Protection State=0x00:
Normal unprotected state, the Program Switch operates as
described in the Operation section.
Protection State=0x01:
Restricted state, the Program Switch must be pressed
three times instead of only one to manually switch the appliance on or off.
Protection State=0x02:
Fully protected state, the Program Switch is inoperative.
Z-WAVE COMMAND CLASSES
This plugin supports the following Z-Wave Command Classes:
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_PROTECTION
COMMAND_CLASS_SWITCH_ALL
COMMAND_CLASS_SWITCH_BINARY
COMMAND_CLASS_VERSION
4
Summary of Contents for z-wave
Page 1: ......
