Reminder Function
：
a. Press REMINDER button "A" to activate the function. The LED display shows " " or " ".
b. Two seconds later, press the "▲" or "▼" button to adjust the reminder time only when the display screen
flashes. The default time of the reminder is 45 minutes, which is shown as " ". Then press any button to
save the time setup, or wait 5 seconds and system will save the time setup automatically. During the
countdown, any operation will lead to a repeat starting of the timer. When the countdown finishes, display
screen will show “ ” the buzzer will be active with a 10-second "DiDi...DiDi...DiDi..."tone.
c. Within the 10-second reminder buzz, press any button to reactivate the time countdown that is set up in
(b) step. If no operation during the 10-second reminder buzz, there will be another reminder buzz after 5
minutes. No operation during the second buzz will turn off the Long-Time Sitting Reminder.
d. Press and hold the "A" button for three seconds to turn off the Long-Time Sitting Reminder. The LED
display shows " " or " ".
Mount the adapter arm (7) on the supporting
beam (4) before attaching the table top.
Mount the tabletop with screws (F). Attach the control
box (9) to the tabletop with screws (F) and insert the
adapter to the adapter arm. Mount the handset (10)
to the tabletop with screws.
The desk has seven control buttons on the handset.
b. When it does’t work and the LED shows “E01” or “E02”, 18 minutes later to allow the desk to cool down
from a possible overheat protection status.
please
The following tips will help you with possible common faults and errors.
If the fault you encounter is not listed below, please contact customer
support.
Troubleshooting
Fault
Troubleshooting method
No response when pressing buttons after
connecting the power supply, including
pressing and holding the down or up arrow
buttons
Slow desk rise speed
Desk height slides downwards or keeps
changing
Check that all cables are connected properly
Check that the desk is not overloaded and within
the 220lb load rating
Check that the desk is not overloaded and within
the 220lb load rating
Desk goes down but does not go up
Check for overloading. Check that there are no
obstacles or tangled cables.
Desk unresponsive, overheat or overworked
Not enough height adjustment range
Keep the desk plugged in and wait for the desk to
restart in approximately 18 minutes
(duty cycle: 2 minutes operation, 18 minutes stand by).
Press “M” and “3” together for 3 seconds until 2
beeps are heard to restore factory settings.
+
