11
RACK MOUNTING
The amplifier includes two rack mount ears and screws to attach them to the sides. Note
that, due to the weight of the amplifier, it is recommended that rear supports be secured
to the rear rack rails. Hardware to do this is not supplied because it is specific to the type
and depth of rack being used.
Note that you can remove the rubber feet from the bottom of the amplifier when
mounting it in a rack. To do so, use a Phillips screwdriver to remove the screws securing
the feet to the bottom of the amp.
DSP MENU OPERATION
To operate the DSP menu system, use the NAVIGATION CONTROL on the front panel.
When the amplifier is powered on, the LCD screen will display the Home Screen, which is
also the Master Volume menu page. While this menu page is displayed, turn the control to
change the volume level.
After 30 seconds of inactivity, the menu screen will go dark. After 5 minutes of inactivity,
the menu system will return to the Home Page/Master Volume menu page.
Note that you must save the settings to one of the three memory storage locations or they
will be lost when the amp is powered off. When the amp is powered on, it will revert to
either the last preset or memory setting.
Perform the following steps to navigate the DSP menu system.
1.
Repeatedly push the NAVIGATION CONTROL to switch to the next menu page until
the desired menu page is displayed.
2.
Turn the NAVIGATION CONTROL to set the parameter to the desired value.
3.
Push the NAVIGATION CONTROL to switch to the next menu page and save the set
value.
Refer to the
DSP MENU MAP section below to see a visual representation of the menu
pages and parameter options. Refer to the
DSP MENU DETAILS section for detailed
explanations of each menu page function and parameters.