Self Amplified Digital Keypad with Bluetooth and Analog Inputs
5
INSTALLATION
1. Connect a pair of speaker wires from the installed speakers to the
OUTPUT
terminal
block on the device. Pay close attention to left/right orientation and ensure that the
+/- polarity is properly maintained.
2. Obtain a 24 VDC power source (not included). Connect the positive output of the
power source to the
V+
terminal and the negative output to the
G
terminal. Once
power is applied the unit will be in standby.
3. (Optional) If you intend to use the IR repeater functionality, connect the positive wire
from an IR Transmitter/Emitter to the
IR OUT +
terminal and the negative wire to the
IR OUT -
terminal. Position the IR bulb so that it can "see" the IR receiver on your
source device(s).
4. (Optional) If you want to make a hardwired internal connection, connect the audio
source right channel positive to the
R+
terminal. Connect the audio source left
channel positive to the
L+
terminal. Finally, connect the audio source negative wires
to the
G
terminal between the L+ and R+ terminals.
5. Test the unit to ensure that all inputs and outputs are operating properly. Check the
balance of the speaker volume. If it is not in proper balance, you can adjust the
balance using the Balance Trim Pots on the back of the amplifier.
6. Mount the plate as desired. After it is secured in place, install the front cover to hide
the installation screws.
DVD
IR EMITTER
