10
event that a firmware update is available. Connect the included RS232 cable to the
RS232 terminal block if you want to control the scaler/switch using your computer
and a third party RS232 software. Connect an Ethernet cable to the TCP/IP RJ45 jack
to a network router or switch if you want to control the scaler/switch using a web
browser. You can also connect directly to the Ethernet port on your computer, but
will need to configure your PC's network settings to communicate with the switch.
5.
AUDIO OUT: 5-pin terminal block for connecting an amplifier, powered speakers, or
a mixer. It supports both balanced and unbalanced connections.
6.
DC 24V: DC barrel connector for connecting the included AC power adapter.
IR Remote Control
1.
STANDBY BUTTON: Press the button to power
the unit on or to put it into standby mode.
2.
INPUT BUTTONS: Press the button
corresponding to the desired input to switch
to that input.
3.
AUTO BUTTON: Press the button to enable or
disable Auto Switching.
4.
MUTE BUTTON: Press the button to enable or
disable audio muting.
5.
VOL BUTTON: Press the button to display the
volume adjustment menu on the display, then
press the UP and DOWN arrow buttons to
adjust the volume.
6.
NAVIGATION BUTTONS: Use the arrow buttons
to navigate the OSD menu. Use the UP and
DOWN arrow buttons to adjust the volume
when the volume adjustment menu is
displayed. Press the OK button to select the
highlighted entry in the built-in OSD menu.
