7
3.
HDBT OUTPUTS: Four RJ45 jacks for connecting a Cat6 Ethernet cable to connect
with the HDBaseT™ receivers. The HDCP LEDs illuminate green when the video
contains HDCP protected content. The LINK LEDs illuminate yellow when there is a
valid link with the corresponding HDBaseT receiver.
4.
IR ALL IN: 3.5mm jack for connecting the included IR receiver.
5.
IR ALL OUT: 3.5mm jack for connecting one of the included IR transmitters.
6.
EDID PRESET: DIP switches for setting a fixed EDID value. See the
EDID
MANAGEMENT section for more details.
7.
REMOTE CONTROL: 3-pin Euroblock connector for connecting a computer for pass-
through RS-232 control.
8.
MASTER CONTROL: 3-pin Euroblock connector for connecting a computer for RS-232
control of the splitter.
9.
GROUND: Ground connector.
10.
DC 24V: DC barrel connector for connecting the included AC power adapter.
Receivers
1.
POWER LED: The LED illuminates red when power is applied.
2.
RS232: 3-pin Euroblock connector for connecting a computer for pass-through RS-
232 control.
3.
HDMI OUT: HDMI® port for connecting an HDMI display.
4.
CTRL/UPDATE: This switch controls the behavior of the RS-232 connection. When in
the CTRL position, it serves as a pass-through RS-232 control. When in the UPDATE
