8
INSTALLATION
These installation steps will assume extension of video from a laptop or PC to a remote
location for remote operation of the computer. For other configurations, skip or alter steps
as appropriate. Perform the following steps to install this extender kit.
1.
Ensure that all equipment to be connected is powered off and unplugged from its
power source.
2.
Place the receiver and transmitter next to each other.
3.
Plug the DC barrel connector on one of the AC power adapters into the DC 5V jack
on the transmitter, then plug the adapter into a nearby AC power outlet. The Power
LED on the transmitter will illuminate and the Link LED will begin flashing.
4.
Plug the DC barrel connector on one of the AC power adapters into the DC 5V jack
on the receiver, then plug the adapter into a nearby AC power outlet. The Power
LED on the receiver will illuminate and the Link LED will begin flashing.
5.
Simultaneously press the Pair Button on both the transmitter and receiver. The Link
LED on both the transmitter and receiver should illuminate steadily, indicating that
the receiver and transmitter have been successfully paired.
6.
Unplug the AC power adapters from the AC power outlets, then unplug the DC
barrel connectors from the DC 5V jacks.
7.
Place the receiver in its intended location.
8.
Using a High Speed HDMI® Cable (not included), plug one end into the HDMI input
on your remote display, then plug the other end into the HDMI OUT port on the
receiver.
9.
Plug a USB keyboard into the Keyboard port, then plug a USB mouse into the
Mouse port.
10.
(Optional) If you want to control a device at the source location using an infrared
remote control, plug the included wideband IR receiver into the IR IN jack on the
receiver, then position the receiver bulb where it can receive IR signals from your
remote control. Alternatively, you can point your remote control at the IR Receiver
Window on the front panel.
