7
INSTALLATION
Perform the following steps to install the HDMI® extender.
1.
Ensure that all equipment to be connected is powered off and unplugged from its
power source.
2.
Position the receiver and transmitter in their intended location.
3.
Using a High Speed HDMI Cable (not included), plug one end into the HDMI input
on your remote display or projector, then plug the other end into the HDMI OUT
port on the receiver.
4.
(Optional) If you want to control the remote display from the source location, plug
one of the included IR transmitters into the IR OUT jack on the receiver, then
position the IR emitter where it can transmit IR signals to the IR "eye" on your
remote display.
5.
(Optional) If you want to control the source device from the remote location, plug
one of the included IR receivers into the IR IN jack on the receiver, then position the
IR "eye" where it can receive IR signals from the source's remote control.
6.
Using a Cat6 Ethernet cable of the appropriate length, plug one end into the CAT IN
jack on the receiver, then plug the other end into the CAT OUT jack on the
transmitter. If this cable will be run inside or through the walls, it must be rated for
in-wall use.
7.
(Optional) Using a High Speed HDMI® Cable (not included), plug one end into the
HDMI input on the local display, then plug the other end into the HDMI OUT port on
the transmitter.
8.
Using a High Speed HDMI Cable (not included), plug one end into the HDMI IN port
on the transmitter, then plug the other end into the HDMI output of your video
source device.
9.
(Optional) If you want to control the remote display from the source location, plug
one of the included IR receivers into the IR IN jack, then position the IR "eye" where
it can receive IR signals from display's remote control.
