9
RECEIVER EQUALIZATION
If you see flickering, blinking, or other video anomalies on the remote display, use the EQ
Switches to increase the signal strength. Start with the EQ set to 0, then increase it until
the video anomalies are no longer present. The positions for each of the three DIP switches
for each number value and the approximate HDMI cable length range can be found in the
following table.
EQ Switch Positions
Approximate Cat6 Cable Length
up to 49 feet (15 meters)
49 ~ 98 feet (15 ~ 30 meters)
98 ~ 131 feet (30 ~ 40 meters)
131 ~ 164 feet (40 ~ 50 meters)
INSTALLATION
Perform the following steps to connect and configure the splitter/extender.
1.
Ensure that all equipment to be connected is powered off and disconnected from
its power source.
2.
Place or mount the splitter and the receivers in the desired locations.
3.
Using a High Speed HDMI® Cable (not included), plug one end into the HDMI input
on your display, then plug the other end into the HDMI OUT (2) port on the receiver.
