8
value, depending on the output voltage by your
amplifier.
For example, using the values in the previous examples and
using the 41843 6.5" model, set the tap dial to the 10W
position, which is the 3rd position for 70V systems or 2nd
position for 100V systems.
9.
Attach the Speaker Cover to the speaker, then fasten
the included Eye Bolt to the Speaker Cover and
Speaker.
10.
Feed the Hanging Cable through the Eye Bolt on the
Speaker, then wrap it around the pole or through the
eye bolt where the Speaker will be suspended. Use
one or both of the included Carabiners to secure each
end of the Hanging Cable together.
11.
Gently release the speaker to verify that it is securely
suspended. Gently pull down to ensure the
suspension is secure, while grasping each side of the
speaker to prevent it from dropping or falling.
12.
Repeat steps 5-11 for each speaker in the right and left
channel arrays.
13.
Connect the positive and negative conductors on the
speaker wire from the first speaker in the left channel
array to the left channel speaker terminals on the
amplifier, then repeat for the right channel speaker
wire.
14.
Set the volume level on your amplifier to the
minimum setting.