4
General
This device is intended for indoor use only.
Do not expose this device to water or moisture of any kind. If water does get in or
on the device, unplug it from its power source and allow it to fully dry before
reapplying power.
Do not touch the device, the power cord, or any other connected cables with wet
hands.
Do not expose this device to excessively high temperatures. Do not place it in, on,
or near heat sources, such as a fireplace, stove, radiator, etc. Do not leave it in direct
sunlight.
All wires and cables installed inside the ceiling must be rated for in-wall/in-ceiling
use by the UL or a similar certification agency. An in-wall rating is sufficient for
residential installations, while a riser or plenum rating is required for commercial
installations. Please refer to your local building regulatory agency for guidance.
Do not place or install this device in an area where it can be exposed to excessive
amounts of dust, humidity, oil, smoke, or combustible vapors.
When it is extended, take care not to shake the lift or attempt to manually lift it up.
This device has no user serviceable parts. Do not attempt to repair or disassemble
this device.
The motor requires no periodic lubrication.
Power
This device requires a grounded/earthed power connection for safe operation.
A short power cord is included with this device. However, you can construct a
longer cord or make a permanent, fixed power connection. If replacing the included
cord, use a three-conductor power cord of sufficient gauge to handle 170 watts,
plus the power requirements of the attached projector.
If using a fixed electrical connection (directly wired to a power source), install a
quick disconnect device inline where it can be readily accessible. If using a standard