Monolithelec Android DVBS2 STB, Manual

Page: 22 / 30

Monolithelec Co.,LTD Android 4.0 DVBS2 Satellite receiver http:// www.monolithelec.com
Press
【
/
、
/
】
and
【
OK
】
to enter in
“ Settings”, seeing picture 5-7-2:
图
5-7-2 5-7-2 5-7-2 5-7-2
�
Wi-Fi
Wi-Fi Wi-Fi
Wi-Fi
：
Turn on or turn off WLAN function
Choose upper right
【
BLUE
】
button, then
press
【
OK
】
button. WIFI is open when it shows
“ON”.
�
Wi-Fi
Wi-Fi
Wi-Fi Wi-Fi Setting
Setting
Setting Setting
：
Setup and manage wireless
access point.
System will auto search Wi-Fi internet when
Wi-Fi is open and display the result in Interface.
If no internet is searched, you can add WLAN
access point by hand.
�
� �
� Adding Adding Adding Adding WLAN WLAN WLAN WLAN access access access access point point point point by by by by hand: hand: hand: hand:
Following options are in Wi-Fi list:
Scanning
Scanning
Scanning Scanning
：
Automatically scan WIFI wireless
internet
Add Add Add Add network network network network:::: Press
【
OK
】
button, it will pop
dialog box, as shown in picture 5-7-3:
Advanced Advanced Advanced Advanced
：
Advanced setup Interface is as
below
�
Choose
Choose Choose
Choose Static
Static Static
Static state
state state
state IP
IP IP
IP
：
Whether choose to
use Static state IP mode.
If choose use static state IP mode, the IP
address, Gateway, Netmask, DNS, each
becomes available, you need to setup this
parameter correctly .On the contrary, all of these
settings are invalid.
Use IR remote control to choose static state
IP, press
【
OK
】
button to confirm enter in..
5.7.2. 5.7.2. 5.7.2. 5.7.2. Ethernet Ethernet Ethernet Ethernet Configuration Configuration Configuration Configuration
�
Ethernet
Ethernet Ethernet
Ethernet
：
Click this option , press
【
OK
】
button to turn on or off Ethernet.
�
Ethernet
Ethernet Ethernet
Ethernet configuration
configuration configuration
configuration
：
Set Internet IP and
other parameters.
Click this option, entering Ethernet configuration
interface. Like picture 5-7-4 shows:
图
5-7-3
In the interface of Ethernet configuration
：
�
Ethernet
Ethernet
Ethernet Ethernet Equipment
Equipment
Equipment Equipment
：
Currently can be
applied Ethernet equipment eth0 by
default.
� � � �
Connecting
Connecting
Connecting Connecting mode
mode
mode mode
：
1
）
DHCP Mode
：
Auto obtain IP address
mode.
2
）
Static state IP
：
Static state IP mode
When choose Static state IP mode, need to
setup all IP parameters correctly then save
it.
5.7.3 . Voice Setup
Set related properties, press
【
OK
】
button
to enter in.
图
5-7-4