MONOLITH srl Thanks you to buy a product from our gamma and invites you to read this manual which contains all
the necessary information for a correct use of the item.
The user is required to reading the same before the use and to an use in accordance with the warnings contained in
it.
The User and Maintenance manual has to be available for a correct conservation.
MONOLITH srl reserves the right to make variations or changes to this manual without obligation to notice it to the
customers.
DESCRIPTION:
Electronic sink tap powered by LITHIUM batteries type AA 4x1,5V. Water distribution through activation of sensor
infrared fixed fire.
OPERATING:
The Infrared Sensor (C) (see pict. 1) recognizes the presence of the hands and begins to dispense water until it is
more present or until the maximum closing time elapses (ANTI VANDALIC SYSTEM).
If The system detects an object for about 1 minute, the system automatically closes the water supply until the
object is removed.
The battery exhaustion is indicated by the red flashing light of the LED, the solenoid valve closes and the dispensing
system stops waiting for the batteries to be replaced.
The operation of the faucet is guaranteed only with water without impurities
.
Install the interception taps with filter (not supplied) in the line, to preserve the functionality
of the solenoid valve and for any maintenance operations.
Use only LITHIUM batteries for greater durability and efficiency of the product.
INSTALLATION INSTRUCTIONS:
Always bleed the piping before installation and at
every temporary closure of the system.
1) Close the water supply.
2) Pierce the sink ø33.
3) Manually Tighten the tie rod (2) to the base of the
already assembled tap (1). Insert The sealing base (3)
and O-Ring (4) into the already assembled tap (1).
4) Place the tap on the hole Ø 33 previously made in
the sink, passing the hose (5) and the cable (A) inside
it.
5) Fix the faucet to the sink by inserting under the
sink the shaped gasket (7) then the metal Insert (8)
and tighten the hexagonal nut (6) on the tie rod (2).
Use a clamping wrench SW11.
6) Connect the flexible (5) to the fitting (9).
7) Connect the mechanical pre-mixer (10) to the
fitting (9) after insert the gasket (11).
8) Connect the hoses (12) to the mechanical pre-
mixer (11).
9) Connect the hoses (5) to the water mains.
10)
Fasten the battery holder box (B) to the wall
(under the sink) using the appropriate screws and
plugs (not supplied) after drilling the wall from ø6,
making sure that the cable outlet is facing
downwards as in pic. 1. Place the battery box in the
safe area away from possible damages.
11) Insert The 4 lithium batteries into the box making
sure that the + and-poles are correctly matched.
12) Connect the cable (A) to the battery holder box
(B)
13) The system is set by default as per product
specifications with a closing delay (comfort time) of 6
sec and a self-closing for blinding sensor (vandal
resistant) of 1 min.
1
2
4
3
5
A
SW11
B
C
7
8
6
9
12
10
12
11
pic. 1