INSTALLATION
1.Ensure that the Power Switch on the rear panel of the Master Speaker is in the OFF
position.
2.Plug one end of the included Speaker Connection Cable into the Speaker Input
Connector on the rear panel of the Slave Speaker, then plug the other end into the
Speaker Output Connector on the rear panel of the Master Speaker.
3.(Optional) Using a 3.5mm stereo audio cable, plug one end into the 3.5mm TRS input
Jack on the rear panel of the Master Speaker, then plug the other end into the headphone
output on your mobile device or other audio source device.
4.(Optional) Plug one end of a stereo RCA audio cable into the Stereo RCA Input Jacks on
the rear panel of the Master Speaker, then plug the other end into the output jacks on your
audio source device.
5.(Optional) Plug one end of a digital optical audio cable into the digital optical input jack
on the rear panel of the Master Speaker, then plug the other end into the output jacks on
your audio source device.
6.(Optional) Plug one end of a USB cable into the USB input jack on the rear panel of the
Master Speaker, then plug the other end into the output jacks on your audio source
device.
7.Plug one end of the included AC Power Cord into the AC
power inlet
, then plug the other
end into a nearby AC power outlet.
THE MULTI-FUNCTION KNOB
The multi-function knob at the front of the Master Speaker offers push and turning
functions. This knob controls the basic functions :
1.
ON/Standby:
A short push can power ON the speaker, “Stand by” can be forced by a
longer push (>2s) on the knob.If set “Stand by” manually, a static weak white LED will
confirm this.In case of automatic standby, this will be visible through a slowly blinking
white LED.
2.
Volume control:
If the device is ON, by turning the knob, the volume can be increased
or decreased.After switching OFF and ON, the previous volume setting is recovered.
3.
Sequencial input selection
(short push on the knob when the device is ON):
Line1:AUX
Line2:RCA
Line3:BT
Line4:OPT
Line5:USB
