8
49-80404-4
Care and Cleaning
Chimney Vent Hood
Stainless
steel
surfaces
(on some
models)
Do not use a steel wool pad; it will scratch the
surface.
To clean the stainless steel surface, use warm
sudsy water, a stainless steel cleaner such as
Kleen King
®
or an all-purpose liquid or spray
cleaner. Always scrub in the direction of the
grain. Rinse thoroughly with a sponge or cloth
and clean water. Dry with a soft, clean cloth.
After cleaning, use a stainless steel polish, such
as Stainless Steel Magic
®
, Revere Copper and
Stainless Steel Cleaner
®
or Wenol All Purpose
Metal Polish
®
. Follow the product instructions
for cleaning the stainless steel surface.
Painted
surfaces
(on some
models)
Glass visor
Light bulbs
Clean any painted surfaces with a mixture of
water and either soap or vinegar.
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
Pull the glass visor out and wash it with a
damp soapy cloth. Dry it with a clean cloth and
push it back into place.
NOTE:
The glass cover should be removed
only when cold. Wearing latex gloves may
offer a better grip.
CAUTION
Before replacing the bulb,
disconnect electrical power to the hood at the
main fuse or circuit breaker panel.
ATTENTION
Avant de remettre en place
l’ampoule, débranchez le courant de la hotte en
enlevant le fusible principal ou en faisant basculer
le disjoncteur au panneau d’alimentation.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with
bare hands or a damp cloth.
To remove:
1 Insert your finger nail into the inner glass
cover slot and pull down. Remove cover.
NOTE:
Do not remove outer retaining ring.
2 Using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
1 Use a new 12-volt, 20-watt Halogen bulb
for a G-4 base.
2 Using gloves or a dry cloth, remove the
new bulb from its packaging.
NOTE:
Do not touch the new halogen bulb with
bare fingers. Touching the bulb with bare fingers
will significantly reduce the life of the bulb.
ONLY use a new 12-volt, 20-watt Halogen bulb
for a G-4 base.
3 Push the bulb straight into the receptacle all
the way.
For improved lighting, clean the glass cover
frequently using a damp cloth. This should be
done when the hood is completely cool.
4 Snap the glass cover into the retaining ring.
5 Reconnect electrical power to the hood.
Bulb
Socket
Glass cover
Receptacle
Receptacle
Use gloves or cloth
