Monogram ZV750, Owner'S Manual

Page: 8 / 36

8
49-80569 Rev. 4
LIGHT BULBS
NOTE: The glass cover should be removed only when
cool.
CAUTION
Before replacing the bulb, disconnect
electrical power to the hood at the main fuse or circuit
breaker. Allow bulbs to cool before touching.
Be sure to let the light cover and bulb cool completely.
For safety, do not touch a hot bulb with bare hands or a
damp cloth.
To change the light bulbs:
1.
Remove the lamp lens cover by inserting a small flat-
blade screwdriver into each of the three slots and gently
prying it free.
NOTE: Do not remove the outer trim ring (lamp assembly).
2. Grasp the bulb and pull it straight out.
3. Using gloves or a dry cloth, remove the new bulb from
the packaging. (Wearing latex gloves may offer a better
grip.) The bulb must be the same wattage, 120-volt,
25-watt halogen with a G-9 base. Early bulb failure may
occur if wattage is too high.
4. Push the bulb straight all the way into the receptacle.
5. Replace the lens cover by inserting the three retaining
tabs into the slots and pressing into place.
NOTE: For improved lighting, clean the glass cover
frequently using a damp cloth. This should be done when the
hood is completely cool.
6. Reconnect electrical power to the hood.
NOTE: Order replacement 120-volt, 25-watt halogen bulb
with G-9 base, WB25X10020.
These bulbs can be ordered from your Monogram supplier.
NOTE: Make sure the tabs are inserted into the slots.
ONLY use a new 120-volt, 25-watt halogen bulb with a
G-9 base.
NOTE:
Do not touch the new halogen bulb with bare
fingers. Skin oils can cause early lamp failure.
Use a small flat-blade screwdriver
to remove the lamp lens cover.
Outer trim ring (lamp
assembly) Do not
remove
Bulb
Removable inner
lamp lens cover
Tab
Receptacle
Use gloves
or cloth
CARE AND CLEANING