Monogram ZIS420 Series, Installation Instructions Manual

Page: 21 / 116

21
STEP 11 INSTALL 1/4” (0.63 cm) FRAMED PANELS
Install door panels:
• Open the door to 90°.
• Remove the 6 screws holding the door trim on the
handle side, then lift off the trim. Retain the screws.
• Slide the framed panel into the door trim.
Dispenser Models Only:
• IMPORTANT: The dispenser controls protrude beyond
the face of the freezer door. To avoid damage to the
dispenser, the trim at the top of the door should be
removed.
• Remove the screws holding the top trim in place.
• Place the freezer panel into the bottom channel and
slide into the hinge side trim.
• Reinstall the top trim piece with screws.
All Models
• There are two sets of holes in the door trim on the
handle side. Replace the handle side door trim by
installing the original screws in the FRONT screw
holes.
• Secure the visor handle from kit ZKLN to the door
using the REAR screw holes.
• Follow the same procedures to install the opposite
panel.
• Check to be sure the handles are evenly aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
NOTE: Aluminum cover trim is supplied for use with
custom handles on overlay panels. It is not intended for
use with 1/4” (0.63 cm) panels. Discard the cover trim
when using 1/4” (0.63 cm) framed panels.
Go to Step 11A for Overlay Panels
Visor Handle
Shown in 1/4”
Panel Position
from kit ZKLN
Optional Visor
Handle from kit
ZKLN
Door
Trim
Refrigerator
Door
Installation Instructions - Standard Installation
Use Front Holes
to Secure Trim
Use Rear Holes to Secure
Visor Handle from kit ZKLN
Top Trim
31-1000450 Rev. 1