Monogram.
™
Specification Created 12/99
For answers to your Monogram,
®
GE Profile Performance Series,
™
GE Profile
™
or GE appliance questions, call
GE Answer Center
®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
X
Installation Height
Dimension A
83"
8"
83-1/2"
8-1/2"
84-1/2"
9-1/2"
ZISB36DC - GE Monogram 36" Built-In Refrigerator with Dispenser and
Water Filter
Dimensions and Specifications (in inches)
35"
9"
1/4" Thick Panel
Custom Grille Panel
(not to scale)
Panel frame is factory assembled for 84"
installation height. If installation height
varies, order ZG2 trim kit which provides
optional side trim panels. Cut Lexan
®
or
stainless panels to sizes shown below.
9 7/16"
12 5/16"
Custom Dispenser
Cutout
The Cutout is 9 7/16"
wide by 12 5/16" high.
Custom Door Panel Dimensions Using Standard Trim
1/4" thick panels or Panels secured to 1/4" thick backing
1 1/4"
Clearance
hinge side
2" Clearance
handle side
Appearance
Panel
1/4"
Thick
Backing
Raised Panel on 1/4" Thick Backing
Door
Handle
Case Trim
16-5/8"
36-7/8"
2-9/16"
67-7/8"
15-1/4"
15-1/4"
19-1/4"
17-11/16"
Fresh Food Panel
Freezer Panel
Standard
Dispenser
Freezer Panel
Custom
Dispenser
Standard Trim with 1/4” Panels:
1/4” Panels: Cut panels to size.
Custom handles with 1/4” door panels require Trim Kit ZKH1. When using
ZKH1 with the standard dispenser trim, the length of the custom handle,
top to bottom cannot exceed 11-3/4”.
Tubular stainless steel handle kit ZKHSS1.
Custom collar dispenser trim with 1/4” door panels require trim kit ZWCD1.
Standard Trim with Panels secured to 1/4” thick backing:
Applying a
raised panel design to a 1/4” thick backing (screwed or glued): Cut 1/4”
panels to size, fabricate the raised panel to permit clearances of at least 2”
from the handle side for fingertip clearance, 1-1/4” from the hinge side to
avoid striking adjacent cabinetry and 5/16” from the top and bottom edges
to allow for the trim flange, then install.
Countertops adjacent to refrigerator installation should be mitered 45°
degrees.
Note:
ZWCD1 custom collar dispenser trim and ZKHT1 custom handle kits
cannot be used in this configuration.
Important:
Maintain 1-1/2” min. gap
between top of doors and bottom of panel
frame.
