CUSTOMIZATION BASICS:
Framed Or Overlay Panels, Custom
Handles and Accessory Kits
These refrigerators are designed to be customized with
decorative panels. Field installed custom door and grille
panels are required.
Side Panels
Side panels must be used whenever the sides of the
refrigerator will be exposed.
7
Optional Accessory Kits
• ZKHFD2H: Monogram Tubular Stainless Steel handles
designed to fit 3/4
”
overlay panels.
Design Guide - Standard Installation
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C). It will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
CUSTOM HANDLE DESIGN GUIDE
Custom handles must be used for flush installation. For
custom handle installation, counterbore holes in rear of
decorative panels must ensure 1/2” material thickness
remains for handle support.
NOTE: The counterbore must not exceed 1” in diameter.
Minimum distance on Fresh Food Doors from handle side
edge to handle center should be 1-1/4” on each door as
shown.
Minimum distance on Freezer Door from top edge to
handle center on the freezer drawer should be 1-1/4” as
shown.
7/8"
1-1/10"
3/4"
Countersink screw
into panel as shown.
1-1/4”
1-1/4”
1-1/4”
