background image

Installation Instructions

STEP 3   LEVEL

Use an adjustable wrench to turn and raise or lower the 
leveling legs. 
• Measure floor to countertop height inside the opening. 

Adjust leveling legs until the product is approximately 
1/8” less than countertop height.

INSTALLATION TIP:

Measure floor to underside of countertop inside 
the opening.
• If the room floor is higher than the floor inside the 

opening, adjust the rear leveling legs to approximately 
1/8” less than the opening height. Screw front leveling 
legs all the way in to shorten the height at the front. 
This will allow you to slightly tip the unit into the 
opening. Once the unit is in the correct position, 
the front legs can be adjusted to level the product.

Turn Right to Lower

Turn Left to Raise

STEP 4  CONNECT POWER

•  Connect power cord plug to a properly grounded 

receptacle.

•  Check to make sure power is on by opening a drawer 

to see if interior light turns on.

•  The interior fan runs all the time except when a drawer 

is open.

   See the Owner’s Manual for further explanation of the 

fan.

STEP 6   SET TEMPERATURE 

CONTROLS

• The temperature controls are preset. Refer to the 

Owner’s Manual for more information. Allow 12–24 
hours for the temperature to stabilize.

NOTE: 

The Double-Drawer Refrigerator operates very 

quietly. You may not notice the unit running, and when 
first installed, the fans and motor may not come on 
immediately  – this is normal. If the display is lit and the 
light is working, the unit is operating.

STEP 5   SLIDE PRODUCT INTO 

THE CUTOUT

NOTICE: 

Do not push against the drawer panels with 

your knees. Do not push or lift the unit by the drawer 
handles. Damage may occur! 

•  Open one of the drawers and gently push the unit 

back into the opening with your hands against the 
sides. Be careful not to entangle power cord.

• Check again to be sure the unit is level. 

Adjust the 

leveling legs until the unit is resting firmly against 
the bottom of the counter to prevent rocking or 
movement during operation.

• If alignment with adjacent cabinetry is an issue, use 

a shim to secure the unit against the underside of the 
countertop.

31-51545-6

9

Summary of Contents for ZIDI240HII













Reviews: