Installation Instructions
12
• Insert the bolts into the toggle by hand until snug.
Tighten with a wrench.
Anti-Tip Wall Bracket
Bolt
Wall Toggle
Drywall or
Steel Stud
STEP 4 INSTALL ANTI-TIP BRACKET
(cont.)
Install Wall Toggles:
The wall toggles and bolts can be ordered as Service Kit
#WR49X10193. Wall toggles are installed in the drywall
and metal studs for stability. Install the wall toggles as
follows:
• Drill 1/2” holes at the wall markings made in the holes at
the ends of the wall bracket.
+ROGWKHPHWDOFKDQQHOIODWDJDLQVWWKHSODVWLFVWUDSV
and slide the channel through the hole.
• Gently pull back at the ends of the plastic straps to
make the channel rest flush behind the wall.
+ROGWKHHQGVRIWKHVWUDSVLQRQHKDQGDQGVOLGHWKH
plastic cap along the straps until the flange of the cap is
flush with the wall.
• Place your thumb between the plastic straps and bend
up and down to snap the straps off at the wall.
Install Screws and Bolts:
+DYHVRPHRQHKROGWKHZDOOEUDFNHWFHQWHUHGLQSODFH
with each of the holes aligned with the correct opening
in the bracket and level with the horizontal line.
• Insert the lag screws through the bracket and into the
stud. Tighten with a wrench.
Plastic Straps
Metal Channel
Cap
Wood Stud
Lag Screw
Anti-Tip Wall Bracket
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible,
do so now.
Move Unit into Final Position
• Open the access panel.
• Move refrigerator toward its final installed location. Align
the tabs on the wall bracket with the openings in the back
of the unit.
• The unit has an “L” bolt in the upper left corner inside of
the access compartment. This bolt will interlock with the
wall bracket and secure the unit using the washers and
hair pin cotter in the hardware kit once the unit has been
leveled and is in the final position.
Summary of Contents for ZICS360NXLH
Page 19: ...19 Notes...
