Monogram ZDWR240NBS, Installation Instructions Manual

Page: 9 / 12

31-46122-7
9
CUSTOM FRAME PANEL MODELS
Model ZDWI240WII and ZDBI240WII
These models require a custom panel frame surrounding
the glass. There are two options: the panel may be 29-
ƎRUƎKLJK$ƎSDQHOUHTXLUHVDQRWFKFXWLQWRWKH
bottom of the panel to avoid interference with the hinges.
• Rout the back side of the panel to the dimensions
shown.
• A custom handle of your choice or ZTBSS1 Tubular
Handle must be installed before the panel is mounted
onto the door.
NOTE: A solid panel that covers the door glass
CANNOT be installed on these models.
CUSTOM FRAME PANEL MODELS
(Cont.)
Model ZDWI240WII and ZDBI240WII
Install the custom panel:
• Open the door fully.
• Remove the gasket surrounding the inside of the door
to expose the existing screw holes for the custom
panel.
• Hold the custom frame panel against the door and
align carefully, top to bottom and side to side. Mark
screw hole
locations on the back side of the panel.
• Drill pilot holes in the back side of the custom panel. In
KDUGZRRGGULOOƎSLORWKROHV,QVRIWZRRGGULOOƎ
holes.
• Secure the prepared panel to the door using ten (10)
[ƎVFUHZV'ULYHWKHVFUHZVWKURXJKWKHGRRU
frame and into the wood.
• Replace the gasket.
Installation Instructions
#8 x 5/8"
Screws
GLASS
Back
Custom
Framed
Panel
Door
Frame
23-1/8”
30”
GLASS
25-1/4”
18-5/8”
2-1/4”
Rout the back
side of the
opening 7/16”
deep, 1-1/8” wide
Cut the notch
1/8” deep, 1/4”
wide and 1/4”
high
2-1/4”
1/8”
1/4”
1/4”
2-1/4”
2-1/2” at
bottom
23-1/8”
29-3/4”
GLASS
25-1/4”
3/4” Thick Custom Panel,
Back Side
18-5/8”
2-1/4”
wide,
all sides
Rout the
back side
of the
opening
7/16”deep,
1-1/8” wide
Choose Option 1 or Option 2 panel size depending on
cabinetry size or style.