General Safety
CAUTION: It is essential that all instructions in this manual be
followed to ensure proper operation of the equipment and safe-
ty of operating personnel. The use of this symbol is used
throughout this manual to highlight important safety issues.
Please pay particular attention to these items.
Electrical Shock Caution
AOE Auxiliary Output Enclosures are powered with HIGH
VOLTAGE. No operator serviceable parts are inside. All ser-
vicing is to be performed by qualified personnel. Each AOE is
provided with a "protective conductor terminal" which shall
be terminated to earth ground potential (see Electrical
Installation). This product's design complies with EN61010-1
installation category II and pollution degree 2.
Electromagnetic Compatibility (EMC)
The AOE was tested and found to comply with the standards
listed below. The AOE should not be used in residential or
commercial environments. Compliance to the EMC standards
was demonstrated by means of a test setup using the following
installation methods.
1) AOE enclosure was connected to earth ground (protective
earth) .
2) Shielded cable was used to interconnect the RS-485 net-
work (connections D+ and D -). The shield drain was con-
nected to earth ground (SHD terminal) at each end.
EMC Emissions:
Meets EN 61326-1 Electrical Equipment for Control Use,
EMC
EN 55011 Radiated and conducted emissions
(Class A- industrial)
EN 61000-3 Fluctuation/Flicker
Meets FCC Part 15B RF Devices, Unintentional Radiators
CISPR 11 Radiated and conducted emissions
(Class A- industrial)
EMC Immunity:
Meets EN 61326-1 Electrical Equipment for Control Use,
EMC
IEC 1000-4-2 Electrostatic discharge (industrial)
IEC 1000-4-3 RF radiated EM fields (industrial)
IEC 1000-4-4 Electrical fast transients (industrial)
IEC 1000-4-5 Electrical surges (industrial)
IEC 1000-4-6 RF conducted EM energy (industrial)
IEC 1000-4-8 Power frequency magnetic fields
(industrial)
IEC 1000-4-11 Source voltage deviation
B U L L E T I N
344F
MECHANICALS
SAFET Y
SPECIFICATIONS
Monitor Technologies LLC warrants each AOE it manufactures to be free from defects in
material and workmanship under normal use and service for two (2) years from the date
of purchase. The purchaser must notify Monitor of any defects within the warranty period,
return the product intact, and prepay transportation charges. The obligation of Monitor
Technologies LLC under this warranty is limited to repair or replacement at its factory. This
warranty does not apply to any product which is repaired or altered outside of Monitor
Technologies’ factory, or which has been subject to misuse, negligence, accident, incor-
rect wiring by others, or improper installation. Monitor Technologies LLC reserves the right
to change the design and/or specifications without prior notice.
WARRANT Y
Power Requirements: 115 VAC or 230 VAC, 50/60 Hz
Power Consumption: 25 VA Max
Operating Temp: -4° F to 131° F (-20° C to 55° C)
Communication: RS-485 half-duplex, isolated,
proprietary protocol
Analog Outputs: 4-20mA, 16 max, 4 per card, non-
isolated, 500 ohm, 10 bit resolution,
zero/span set via HMI2 or
Silo
Track
Relay Outputs: SPST, 5A @ 250 VAC, 32 max, 8
per card, visual LED per relay,
assignment and action set via HMI2
or
Silo
Track
Enclosure: Painted Aluminum
Overall Dimensions: 11.02" x 9.05" x 4.33" (280mm x
230mm x 110mm)(2-card)
(Hght x Wdth x Dpth) 15.74" x 9.05" x 4.33" (400mm x
230mm x 110mm)(4-card)
Certifications/Protection: NEMA 4, IP66, CE Mark
CHINA RoHS 2
DIMENSIONS ARE SHOWN IN INCHES WITH MILLIMETER EQUIVALENT IN BRACKETS
GDR
JSC
AUG 04 2017
DOC-001-344F 3
Monitor Technologies LLC
44W320 Keslinger Rd.
t
Elburn, IL 60119
t
630-365-9403
t
800-766-6486
t
t
www.monitortech.com
