Bi-Wiring
Bi-wiring is accomplished by connecting separate pairs of speaker cables to the terminals on the loudspeaker
GSPN B TJOHMF QBJS PG DPOOFDUJPOT PO UIF BNQMJˌFS *O UIF DBTF PG UIF (PME 4FSJFT UIF CPUUPN UFSNJOBMT
connect to the bass driver(s) and the top terminals connect to the tweeter in 2 way loudspeakers, or the mid
and tweeter in 2.5 and 3 way loudspeakers.
NOTE: When using this method the terminal links MUST be removed.
Bi-Amping
#J"NQJOHJTUIFTBNFBT#J8JSJOHFYDFQUZPVBSFJOUSPEVDJOHBTFDPOEBNQMJˌFSJOUPUIFFRVBUJPO
In order to Bi-Amp you must connect a set of speaker cables to the top terminals on the loudspeaker from
POFBNQMJˌFSBOEBOPUIFSTFUPGTQFBLFSDBCMFTUPUIFCPUUPNUFSNJOBMTGSPNUIFTFDPOEBNQMJˌFS
NOTE: When wiring this method the terminal links MUST be removed.
5IF&ˋFDUTPG#J8JSJOH#J"NQJOH
Fundamentally a loudspeaker crossover varies the impedance seen by the speaker and by the power
BNQMJˌFS5IFTJUVBUJPOJTTVDIUIBUXIFOUIFGVMMSBOHFNVTJDBMTJHOBMJTBQQMJFEUPUIFUFSNJOBMTPGBGVMM
range speaker system, the bass driver(s) only receives low frequency signals, the mid driver receives the mid
band frequency signals and the tweeter only gets sent high frequency signals. This means that if separate
speaker cables are connected to the low frequency terminals, and the high frequency terminals, not only
have the drive units and the frequency’s directed and divided for them, but the two separate speaker cables
XJMMOPXBMTPDBSSZEJˋFSFOUTJHOBMTUIFCBTTDBCMFNPTUMZUIFMPXTBOEUIFUXFFUFSDBCMFNPTUMZUIFIJHIT
Once the high and low frequencies have been separated in this fashion, the strong current pulses and surges
demanded by bass drivers when reproducing bass or drums, will not interact with the delicate sounds of a
ˍVUFPSDZNCBM
LEFT
+
-
RIGHT
AMP
+
-
LEFT
+
-
RIGHT
AMP
+
-
LEFT
+
-
RIGHT
AMP
+
-
Gold Series
10
Summary of Contents for Gold 200
Page 1: ...o w n e r s m a n u a l...
