USB Firmware Update
To update the firmware by USB memory stick the update firmware needs to be
downloaded first.
NOTE:
The memory stick must be formatted as FAT32 and the file that is
downloaded saved on to the root folder of the drive.
1.
On your PC/ Mac open the internet browser and go to www.monitoraudio.com
and navigate to either the ASB-10 page or the Support page.
2.
Download and “unzip” the update file.
3.
Copy the file named ‘asb1_mcu.bin’ or ‘asb1_ess.rom’ and save it to the
USB stick. When it has been copied/ saved, safely remove the USB stick.
4. Ensure the ASB-10 is switched on and out of standby mode. Then press
and hold the standby button until the LED on the front starts to flash
Purple.
5.
Insert the USB stick into the USB input on the ASB-10 (item 6 on page 3).
The ASB-10 will switch to standby once the update is complete.
LED Brightness Control
Whilst in standby mode, hold down the 3D button on either the ASB-10 or remote
for aproximatley 3 seconds. The front LED will turn White and brightness can be
adjusted with the volume controls. The ASB-10 will go back into standby after
aproximatley 3 seconds of no activity.
Changing the Remote Battery
1.
Holding the remote in your hands with the buttons facing up, pull out the
draw in the bottom of the remote whilst pushing in the locking tab.
2. Completely remove the drawer to reveal the battery.
3. Replace only with the same type, CR2025 3v.
4. Slide the drawer back into the remote.
Trouble Shooting
If experiencing problems with the Airstream ASB-10, there are some quick and
easy checks, which may help to solve these problems.
Unable to Connect using Bluetooth
•
Check that your streaming device is Bluetooth enabled and paired with
the ASB-10.
•
If you cannot find the ASB-10 you may need to enable the discovery of
devices.
•
Keep away from potential sources of interference which may affect
Bluetooth signal, such as microwave ovens.
•
If you cannot connect to the ASB-10 and the ASB-10 is displaying a solid
Cyan LED in the Bluetooth input then another device may already be paired
with the ASB-10. Hold down the Bluetooth Source button (item 3 on page
3) to unpair the connected device and make the ASB-10 discoverable
(refer to page 9 for further information).
•
If audio is breaking up, reduce the distance from the ASB-10.
The ASB-10 has Forgotten my Bluetooth Device
•
The ASB-10 will only remember one Bluetooth device at a time, Once a
new device has been paired the original device will be forgotten.
No Sound
•
Check the volume, mute, source and play/ pause settings. The volume
controls will work independently on the device and ASB-10.
•
Check that the mains power lead is connected to the ASB-10 and the
mains power socket and is switched on at the wall.
The ASB-10 is Nonresponsive
•
Check that the mains power lead is connected to the ASB-10 and the
mains power socket and is switched on at the wall.
•
Remove the power from the ASB-10, wait for the LED to go out and then
reconnect the power.
7
monitoraudio.com
ENGLISH
Summary of Contents for ASB-10
Page 1: ...O w n e r s M a n u a l...
