Page 9 of 19
70068 Rev A 7-12-12
REMOVE UNIT
This option allows the user to remove the Sample Head from the vehicle. In most cases, this is
not preferred or recommended, except in rare instances. This may be done for the following
reasons:
•
To prevent theft.
•
To protect your vehicle battery during long periods of inactivity (beyond 5 days), such as a
vacation for several weeks.
To remove the Sample Head, press the TRIGGER from this option, and then remove the unit
when instructed.
DO THIS BY GRASPING THE KNURLED PART OF THE CONNECTOR
BARREL ONLY, AND PULL IT STRAIGHT BACK UNTIL THE CONNECTOR RELEASES.
MAKE CERTAIN THAT YOUR PROVIDER HAS DEMONSTRATED THIS TO YOU DURING
YOUR INSTALLATION APPOINTMENT.
When you reconnect the unit, it may require a short
amount of time to re-establish communication, do a system check and warm up. It may display
INITIALIZING or STANDBY. When you see the asterisk (*) scroll across the bottom of the
screen, you may wake the unit up and proceed.
NOTE: THE QUICTEST MAY BE CONNECTED TO A SIREN UNDER THE HOOD, OR YOUR
VEHICLE’S HORN. AS AN ANTI-THEFT MEASURE, IF THE SAMPLE HEAD IS REMOVED
WITHOUT SELECTING THIS OPTION, THE VEHICLE SIREN WILL SOUND
.
SERVICE MODE
This option is used if the vehicle requires automotive (non-Interlock) service by a mechanic. To
use this function, instruct the mechanic to call Monitech and to ask the operator for QuicTest
Support.
OVERRIDE MODE
In the event that the unit is in PERMANENT LOCKOUT, due to a malfunction, missed Monitor
Appointment, or violation recall, it may be possible to have the Service Provider Office issue a
code that will override the lockout, and allow you to take a breath test and drive for a limited
amount of time until you can get to a Service Center. To use this option, call your Interlock
Service Provider, and ask the operator for QuicTest Support.
Unless warranted, this service
may require additional charges.
APPOINTMENT CHECK
This allows the user to check the date of the next scheduled Monitor Appointment. To check
your appointment date, press the TRIGGER from this option. Your next appointment date will be
displayed for a few seconds, and then return to the Menu Mode. (This is the appointment made
at the last Service Center visit. Changes to your appointment made over the phone, or
appointments required due to a recall are NOT visible when using this feature).
SYSTEM INFO
This function will display the Serial Number and Firmware level of your QuicTest Sample Head
and Control Module as well as the system date and time.
Section 5
Taking a Breath Test with QuicTest
The following instructions apply for any of the required tests: START, REQUIRED RETEST,
RUNNING, or ARRIVAL.
