86D0024
23
PLACE ROCk wOOL
Before installing logs, place rock-
wool in dime size pieces evenly
over small burner ports starting
in front of the rear deflector shield
towards the front. Avoid placing
rock wool over the slots on rear
and right side of burner and on
large yellow flame ports on front
of burner.
Wash hands after placing rock
wool. Itching may occur.
LOG PLACEMENT
Before you begin
— This unit is supplied with seven (7) ceramic fiber logs. Do not handle these logs with your
bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling the logs, wash
your hands gently with soap and water to remove any traces of fibers.
W
ARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and
other problems may result if the logs are not properly and firmly positioned in the appliance.
Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to
the heater. Only use the logs and 2G-Rw rock wool.
Failure to position the parts in accordance with diagrams below or to use only parts specifically
approved for this heater may result in property damage or personal injury.
Dime-Sized
Pieces of Rock
Wool
FP2011
place rock wool
FP2011
Figure 18 - Place Rock Wool
LG552
ember placement
10/08
Figure 19 - Correct Rock Wool Placement
LG552
W
ARNING
• Use only rock wool
provided with log set.
• Do not add additional
rock wool.
