2. Features and Procedures
Blind Dial
Allows the terminal to dial without checking for a dial tone.
On
Off
(default)
Dial Type
Sets the dial type.
Tone
(default)
Pulse
2.2.11
Moneris Host Parameters (Edit Hosts Menu)
Use the Edit Hosts menu to edit Moneris host parameters.
Transactions menu > CONFIGURATION menu (press the green OK key) > Setup menu > Host >
Edit Hosts menu
Note: For instructions on navigation through the menus, see
IMPORTANT: Some parameters cannot be edited unless the terminal batch is empty. If the "Edit
Not Allwd Batch Not Empty" message appears, perform a
the parameter again.
Comm Link Type
Sets the primary communication type.
Dial
- sets dial as the primary communications type
CommServer
- sets Ethernet as the primary communications type (default)
Alternate Dial
- Do Not Use
ECRi
- Do Not Use
Backup Support
If the terminal is configured for Ethernet communications, this parameter can be used to switch the terminal to
dial communication if Ethernet communication is not available.
must be connected to the Duet base and a
functioning telephone line before the terminal can successfully use dial
communication as a backup.
None -
If Ethernet communication is not available, the terminal cannot process transactions (default).
Auto Backup -
If Ethernet communication is not available, the terminal will display "IP Connection
Failed" then automatically attempt to use the dial line to communicate with the Moneris host.
Prompt Backup
- If Ethernet communication is not available, the terminal will display "Use Backup Com
Confirm". Select
Yes
to have the terminal attempt to use the dial line to communicate with the Moneris
host OR select
No
to cancel the transaction. The "IP Connection Failed" message appears, then the terminal
display the transactions menu.
24
Moneris Vx810 Duet Operating Manual
