Monark Ergomedic 891 E, Manual

Page: 8 / 28

Ergomedic 891 / 8
Brake belt contact surface - brake belt
BRAKEBELT CONTACT SURFACE
The brake belt should be checked now and then to ensure that it has not suffered execessive wear.
If it looks worn it should be replaced.
Deposits of dirt on the brake belt and on the contact suface may cause the unit to operate unevenly and
will also wear out the brake belt. The brake belt contact of the flywheel surface should then be ground of
with a fine sandpaper and any dust removed with a clean dry cloth.
Dismantle cover, see ”Replacement brake belt”.
Set the weight basket in its upper position.
Take off the brake belt to the side.
Grind with a fine sandpaper. see fig. 10.
Grinding is easier to preformif a second individual cautiosly and carefull pedals the device.
Irregulaties on the brake belt contact surface are removed by means of a fine sandpaper or an abrasive
cloth. Otherwise unnecessary wear on the brake occur and the unit can become noisy.
Always keep the brake belt contact surface clean and dry. No lubricant is allowed to be used.
891-009
Brake belt contact surface
Sandpaper
Return strap
Tension center
Lock washer
Stop lever
Stop
Fig. 8.
Fig. 9.
Fig. 10.