Using the 9491 Boot Kit 3
6.
Industrial Version Only.
Put together screw assemblies using the
longer screws. Then, replace the cable.
T a k i n g t h e B o o t o f f t h e P r i n t e r
To take the boot off the printer:
1.
Industrial Version Only.
Remove the cable from the side of the
printer. Save the spacers and longer screws for when you want to
use the printer with the boot.
2.
With Shoulder Strap Only.
Unscrew the knob assemblies on both
sides of the printer (including the shoulder strap, if used), and take
them off.
3.
Pull on the boot and remove it from around the printer.
4.
For both sides of the printer (at the top), put the screw assemblies
together (including either shoulder strap, if preferred), put them into
the threaded inserts and screw them in.
Do not over-tighten the assembly.
5.
Industrial Version Only.
Reattach the cable using the shorter
screws without the spacers.
B l a c k S p a c e r s
