13
English
3.2 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare
that the receiver RU-8011DB / 5 complies with
the directive 2014 / 53 / EU The EU declaration of
conformity is available on the Internet:
www jts-europe com
Restrictions or requirements apply in the fol-
lowing countries:
CZ
DE
EL
FI
FR
IT
LT
MT
PL
In the Federal Republic of Germany, the receiver
requires a
frequency assignment
(for which a
fee is charged)
In other countries, it is necessary to apply
for a corresponding approval Prior to operating
the unit outside Germany, please contact the
MONACOR subsidiary or the corresponding
authorities of the respective country Links to the
national authorities can be found via the follow-
ing Internet address:
www cept org
t
ECC
t
Topics
t
Other spectrum topics: SRD Regulations and
indicative list of equipment sub-classes
t
EFIS and National Frequency Tables
4 Operation
1) Insert the antennas (1) provided into the
antenna jacks (9) and put them in a vertical
position
Hint:
To increase the range and the interference
resistance, use antenna amplifiers from JTS (e g
UB-900I) The amplifiers are supplied with power
via the antenna jacks of the receiver
2) Connect the receiver to the subsequent audio
unit, e g mixer or amplifier Depending on the
input available at the subsequent unit, use one
of the following two outputs:
– XLR output (11):
balanced output for connection to a micro-
phone input (in this case, activate the 20 dB
attenuation:
☞
chapter 5 1 4) or to an input
for units with line signal level
– 6 3 mm output jack (10):
unbalanced output for connection to an
input for units with line signal level
3) For power supply, connect the power supply
unit provided to the power supply jack (13)
and to a mains socket (230 V/ 50 Hz) The
receiver is provided with a strain relief (12):
Lead the cable around the hook at the bottom
of the housing to prevent accidental discon-
nection of the power supply unit from the
receiver
Note:
The power supply unit will still consume some
power when the receiver has been switched off
Therefore, always disconnect the power supply unit
from the mains socket if the receiver is not operated
for a longer period of time
4) Use the rocker switch (8) to switch on the
receiver (
I
= “on”,
O
= “off”)
5 Configuring the System via the Menu
The configuration menu consists of two sections:
RX (settings for the receiver) and TX (settings for
the transmitter) The menu structure can be found
on page 2
1) To call up the menu, keep the button SET (7)
pressed for approx 2 seconds
will
briefly appear on the display; then the selec-
tion mode for the menu section will be acti-
vated: The menu section RX is selected (
starts flashing) To go to the menu section TX,
press the button
(
starts flashing) To
return to the section RX, press the button
2) When the menu section has been selected,
press the button SET repeatedly until the menu
item desired has been reached
3) To change a setting, use the button
or
(6)
4) To save a change, press the button SET The
display will show
Then the menu will
be exited
Note:
Setting the radio frequency requires two steps;
therefore, the setting will be saved after the second
step (after the channel has been selected or the last
three digits of the frequency have been set)
To exit the menu without any changes, press
the button SET repeatedly until
is briefly
shown on the display The menu will be exited
automatically after 10 seconds when no button
is pressed
Further information with regard to the settings
can be found in the following chapters 5 1
and 5 2
