12
English
MICRO
SD
ON
PROT
CLIP
0dB
-10
-30
PA-806DAP
0
10
CH
1
MODE/ PLAY FOLDER RPT/SCAN
0
10
CH
2
0
10
CH
3
0
10
CH
4
0
10
CH
5
0
10
TEL
0
10
BASS
0
10
TREBLE
0
10
MASTER
POWER
PRE/V NEXT/V+
USB
0
10
−10
+10
−10
+10
0
10
3.3 Power supply
For power supply, either connect the jack
“230 V~” to a mains socket (230 V/ 50 Hz) using
the mains cable provided or, for mobile applica-
tions for example, connect the terminals “24 V
⎓
”
to a 24 V DC voltage source .
4 Operation
1) Before first-time operation, make sure that the
initial volume is not too high: Set the control
MASTER for the total volume approximately to
the position “9 o’clock” . Then switch on the
amplifier with the switch POWER . The green
power LED ON will light up .
2) Use the controls CH 1– 5 and TEL to mix the
signals of the audio sources or to fade them
in or out . Set the controls of the inputs which
are not used to “0” .
3) Adjust the total volume with the control
MASTER . The LEDs “−30, −10, 0 dB, CLIP”
will indicate the output level . To prevent dis-
tortions, only turn up the control MASTER to
such a level that the red LED “CLIP” will not
light up .
4) Use the controls BASS and TREBLE to adjust
the sound .
5) If the LED “PROT” lights up, the amplifier is
overheated or overloaded or has a short circuit
at one of the speaker outputs . In this case,
switch off the amplifier and have the fault
eliminated .
When a storage medium is inserted in the music
module, the replay will automatically start after
the amplifier has been switched on . When two
storage media are used, the memory card will
take precedence . When no storage medium is
inserted, the operating mode most recently used
(Bluetooth receiver, digital radio, FM radio) will
be resumed (chapter 4 .2) .
4.1 Infrared remote control
8
9
7
5
6
4
2
3
1
0
RPT U/SD
SCN
EQ
VOL
−
VOL+
Mode
Power supply of the re-
mote control for the
music module is provided
by means of a 3 V button
cell . If the remote control
is supplied with the bat-
tery inserted, remove the
protective film (to protect
the battery against dis-
charge) from the battery
support: The remote con-
trol will then be ready for
operation . When pressing
a button on the remote
control, always point the
remote control at the IR
sensor above the USB port .
Make sure that there are no obstacles between
the IR sensor and the remote control .
If the remote control is not used for a longer
period of time, remove the battery as a precau-
tion . It may leak and damage the remote control .
4.1.1 Replacing the battery
1) Push the latch of the battery holder to the
right (first arrow in the figure below) and re-
move the holder (second arrow) .
1.
2.
2) Remove the old battery and insert the new
battery (3 V button cell, type CR 2025) into the
holder with the positive pole facing upwards .
3) Push the holder back into the remote control .
Never put discharged batteries in the
household waste . Always dispose of
the batteries in accordance with local
regulations .
