2
1
[
PE
L+
Supply
24 V DC
/+out
008-AP01
Run the connection cable in a way that no traction can occur at the
pressure transmitter.
2.3 Electrical connection
2.4 Cable gland
- After electrical connection, tighten the cable gland.
- Screw the cap nut, until the cable entry is closed tightly.
2.5 Cable run
gasket at the provided flange or flange socket and fix it with
4 washers and screws M8.
- Position the pressure transmitter (flange horizontal) with the
instructions, before handling with the device !
2.1 Preparation
- Check the membrane of visual transport damage.
2. Installation
2.2 Mounting in the vessel
- Read and follow the safety instructions and the operating
- Weld the flange socket (as a option) vertical (flange is horizontal)
in the silo top.
M LLET
Füllstandtechnik
GmbH
02
MSD-420-BA 09/20
©
by MOLLET
Operating instructions OLLET D-74706 Osterburken Tel. +49 6291 6440-0 Fax +49 6291 9846
008-0700
correctly.
- Put the pressure transmitter into operation only, if the installation in
the silo or vessel and the electrical connection have been done
3.2 Normal operation
3.1 Commissioning
3. Use
-
4. Maintenance and servicing
- Damaged devices have to put out of operation immediately.
- Use the pressure transmitter in its intended use only.
modification, the warranty of the manufacturer will be cancelled.
3.3 Inexpert handling
- Not intended use.
- Modification at the device.
- Comply with the specifications on the data plate.
- Violation against applicable law and standards.
- Ignoring of the safety instructions and the operating instructions.
- The pressure transmitter must not be modified. If there is any
maintenance.
- Protect the membrane from damage.
-
4.1 Maintenance
- In case of intended use, the silo pressure transmitter needs no
- The servicing of the pressure transmitter may be carried out by the
4.2 Servicing
manufacturer only.
5. Storage
- Store the pressure transmitter dry and dust-free.
-
6. Disposal
- The pressure transmitter can be recycled.
- The disposal applies to the valid environmental guidelines
according to the location of the carrier and the local manufacturing
-
conditions.
MOLOS
Silo pressure detector
MSD-420
