[
2. Installation
gasket at the provided flange or flange socket and fix it with
2.3 Electrical connection
Circuit diagram
instructions, before handling with the device !
2.2 Mounting in the vessel
- Weld the flange socket (as a option) vertical (Flange is horizontal)
2.1 Preparation
- Position the pressure detector (Flange is horizontal) with the
- Check the membrane of visual transport damage.
- Read and follow the safety instructions and the operating
4 washers and screws M8.
in the silo top.
2.4 Cable gland
- After electrical connection, tighten the cable gland.
- Screw the cap nut, until the cable entry is closed tightly.
2.5 Cable run
Run the connection cable in a way that no traction can occur at the
pressure detector.
- The switching point is adjusted at 40 mbar.
2.6 Switching point
- A modification may be carried out by the manufacturer only.
M LLET
Füllstandtechnik
GmbH
02
MSD-BA 04/13
©
by MOLLET
Operating instructions MOLLET D-74706 Osterburken Tel. +49 6291 6440-0 Fax +49 6291 9846
008-0700
the silo or vessel and the electrical connection have been done
correctly.
3. Utilization
- The pressure detector must not be modified. If there is any
modification, the warranty of the manufacturer will be, cancelled.
3.3 Inexpert handling
- Put the pressure detector into operation only, if the installation in
- Damaged devices have to put out of operation immediately.
- Comply with the specifications on the data plate.
- Use the pressure detector in its intended application only.
3.2 Normal operation
3.1 Commissioning
- The disposal applies to the valid environmental guidelines
conditions.
4. Maintenance and servicing
- Ignoring of the safety instructions and the operating instructions.
- Not intended use.
maintenance.
manufacturer only.
- In case of intended use, the silo pressure detector needs no
- The servicing of the pressure detector may be carried out by the
- Store the pressure detector dry and dust-free.
-
6. Disposal
- The pressure detector can be recycled.
-
4.1 Maintenance
according to the location of the carrier and the local manufacturing
-
- Violation against applicable law and standards.
5. Storage
- Modification at the device or of the switching point adjusting.
-
- Protect the membrane from damage.
4.2 Servicing
008-AP00
P
2
3/4
1
PE
NC
NO
C
1
2
3/4
40 mbar
MOLOS
Silo pressure detector
MSD