1. inclUdEd cOmPOnEnTS
g USO Handset
h Handset Table-Stand
i
Cable guide with angle guard
j
Cable Stopper
k Pulley Guide-Wheel
l
Spring-Retraction Pulley with original
Accessories
Printed Drilling Template
2. nEcESSary maTErialS
•
2× Countersunk M4 screws to fasten the
Handset Table-Stand. Length dependant
on material strength and dimensions of the
furniture housing
•
Suitable screws to assemble the cable
guide and pulley guide
•
Measurement equipment (Tape Measure,
Angle)
•
Fastenings to secure the audio cable
considerations for the assembly Positions
•
a The cable entry at the Table-Stand
•
Individual length of the Handset cable with
flexible steel casing
•
●Maximum cable length of the retraction
pulley (1.6m)
•
Desired/Required retraction force
•
B, c Available room in the furniture for the
assembly positions.
important note:
!
The cable and pulley system must all run along the same plane in the furniture to ensure it runs
smoothly. Ensure the cable enters the cable guide and guard at an angle that does not cause it to
rub against the cable guard. This will cause increased noise and wear on the cable when used.
3. POSiTiOniErUng im möBEl
Prior to beginning assembly, it is necessary to
determine the positions of the Handset Stand
and Cable Guide (A), Pulley Return Guide (B)
and Spring Loaded Retraction Pulley (C).
TaBlE Of cOnTEnTS
1. Included Components
2. Necessary Materials
3. Positionierung im Möbel
4. Assembly of the Table-Stand and Roll Guide
5. Assembly of the Cable Stopper
6. Assembly of the Spring-Retraction Unit
7. Assembly of the Pulley Guide-Wheel
8. Connecting the Handset cable to the Pulley
9. Spring tension Adjustment
2
