APPLICATION SPECIFICATION
REVISION:
ECR/ECN INFORMATION: TITLE:
Installation Instructions PID-00231
MIIM Category 6A Patch Panel
SHEET No.
A
EC No:
MTS2012-0032
4
of
4
DATE:
2013 / 01 / 21
DOCUMENT NUMBER:
CREATED / REVISED BY:
CHECKED BY:
APPROVED BY:
AS-18700-059
BJ Mahendra
CG Raghavan
Samuel Huber
TEMPLATE FILENAME: APPLICATION_SPEC[SIZE_A](V.1).DOC
6. Cable Dressing
6a. Install cable management tray to panel.
6b. Press cables neatly on cable
management tray and secure with cable
ties or Velcro strips ensuring 29 mm
bend radius is maintained.
6c. Individually earth each panel to cabinet
earth position.
7. Attach MIIM I/O cable to I/O port
Secure to cable management tray if desired.
Fig.6
8. RemovalInstructions
To remove rear housing, open clamp and
pull up on latch on top of the housing.
Note
: Use flat screwdriver to
Lift latch of housing.
Fig.8
Fig.7
9. Adding MIIM panels to the MIIM System
Connect a patch cord between the RJ45 port
on the back of the panel to a port on a MIIM
scanner.
Refer to the scanner and panel firmware
update section in the MIIM Installation Guide
to insure the panel firmware and scanner
application are matched correctly.
Access the scanner to confirm scanner
application and panel firmware versions.
If necessary, perform a panel firmware
update on the panel.
MPN NO.
SAP NO.
215-390
187000372
