AT-200 Air-Powered Crimp Tool
Doc No: TM-192790001
Release Date: 07-01-02
UNCONTROLLED COPY
Page 8 of 20
Revision: G
Revision Date: 01-17-14
FILTER REGULATOR
(NOT SUPPLIED)
FOOT SWITCH
BENCH ADAPTER
TO AIR
SUPPLY
SECURE AIR CRIMPING
TOOL IN POSTION
CONNECT TUBING
FROM FOOT SWITCH
WITHOUT FITTING
Figure 2-2
CONNECT TUBING
FROM FOOT SWITCH
WITH FITTING
(NOT SUPPLIED)
TRIGGER
3/8-16 CAP
SCREW
TRIGGER SAFETY
AIR HOSE
(19279-0140)
FILTER REGULATOR
(NOT SUPPLIED)
TO AIR
SUPPLY
TRIGGER
Figure 2-1
Read the following instructions before attempting to operate this tool.
2.1 Set-Up
1.
Connect the air hose to the tool and to the air supply 85 to 95 PSI. Do not exceed 100 PSI.
May cause injury
or damage to the tool.
Air supply must be equipped with a 1/4NPT air filter /regulator which is not supplied by
Molex. See Figure 2-1. (Available from any Industrial supply co.)
If changing to the Optional bench adapter (Order No. 19078-0307) remove the air hose (Order No. 19279-0140) from
the Air-Powered Crimp Tool and connect the tubing from the footswitch. See Figure 2-2. If using the Optional
Electrical Controls (Order No. 64001-4000), see Appendix A.
