Tool Kit for AviKrimp
Fully Insulated and-Insulated Quick Disconnect Flags
Doc No: ATS-6400188HM Release Date: 04-08-15
UNCONTROLLED COPY
Page 2 of 9
Revision: B
Revision Date: 06-17-15
MAXIMUM
INSULATION
DIAMETER
STRIP LENGTH
CONDUCTOR
CRIMP
CUT-OFF TAB
WIRE
SWING
LOCATOR
OPEN
PRESS DOWN
ON THE BRASS
PIVOT SHAFT
LIFT UP ON
THE LOCATOR
Figure 2
ANVILS
POWER
CRIMP
HEAD
Figure 1
PUNCHES
M4 X 10 LONG
BHCS
M4 X 18 LONG
BHCS
DEFINITION OF TERMS
CAUTION:
Install only Molex terminals listed above with this tool. Do not crimp hardened objects as damage can
occur to the tool or die.
INSTALLATION
To install the Tool Kit into the Power Crimp Head follow the steps below:
Anvils and Punches Installation
1.
Insert the Anvils into the bottom slots of the nest. Install the M4 x 10 long BHCS and tighten in place.
2.
Insert the Punches into the top slots of the nest. Install the M4 x 18 long BHCS and tighten in place. See
Figure 1.
Locator Installation and Removal
Follow the steps below to install or replace the locator. See Figure 2.
To install the locator
1.
Position the locator with the hole over the brass pivot shaft and snap it into place.
