
VHDCI Terminator Press
Doc. No: ATS-622004500
Release Date: 08-20-01
UNCONTROLLED COPY
Page 11 of 19
Revision: H
Revision Date: 09-08-17
6.
Make sure the Press
Detent Stop is OUT.
7.
Push the Bottom Slide in.
8.
Lower the Press Ram down to insert the wires
into the wire cover then cut them to the proper
length. Return the Press Ram to the up
position.
9.
Rotate the Press Detent Stop to the IN position
(the raised area of the stop must be under the
stop screw in the press ram).
See Figure 2-5.
NOTE
: The Press Detent Stop must be at the IN
position for the second side termination.
10.
Pull the Bottom Slide out.
11.
Rotate the Plug Retainer to free the
plug and
then fold it forward and load it into
the Plug
Nest.
12.
Push the Bottom Slide in.
13.
Pull the Top Slide out.
14.
Lower the Press Ram until it stops against the
Press Detent Stop to complete second side
termination. Return the Press Ram to full up
position.
NOTE:
The Press Detent Stop must be at the
IN position before lowering the ram
. See
Figure 2-5.
15.
Push the Top Slide in.
16.
Pull the Bottom Slide out.
17.
Remove the completed cable assembly.