Hand Crimp Tool for Sabre™ Female Flat Blade Crimp Terminals
Doc No. ATS-638117300
Release Date: 02-12-07
UNCONTROLLED COPY
Page 5 of 6
Revision: A
Revision Date: 02-12-07
Hand held crimping tools are intended for low volume, prototyping, or repair requirements only.
CAUTION
: Molex crimp specifications are valid only when used with Molex terminals and tooling.
CAUTIONS
1. Manually powered hand tools are intended for low volume or field repair. This tool is
NOT
intended for production use. Repetitive
use of this tool should be avoided.
2. Insulated rubber handles are not protection against electrical shock.
3. Wear eye protection at all times.
4. Use only the Molex terminals specified for crimping with this tool.
CAUTION:
Repetitive use of this tool should be avoided.
Certification
Molex does not certify or re-certify commercial grade hand tools but rather supplies the following guidelines for customers to re-certify
hand tools.
%
This tool is qualified to pull force only. To re-certify, crimp a terminal to a wire, which has been stripped 12.7mm (1/2”) long, so
there is no crimping of the insulation. Pull the terminal and wire at a rate no faster than 25mm (1.00”) per minute. See the
Molex web site for the Quality Crimp Handbook for more information on pull testing.
%
When the hand tool is no longer capable of achieving minimum pull force, it should be taken out of service and replaced.
%
This tool is very difficult to disassemble and reassemble. Customer repair is not recommended.