Hydraulic Press Assembly
Doc No. TM-192861000 Release Date: 10-12-12
UNCONTROLLED COPY
Page 14 of 30
Revision: A
Revision Date: 10-12-12
2.
Select the proper set of dies for the terminal being crimped. The wire size is marked on each die. See
Section 2.4.
CAUTION:
Be sure to use the correct pair of dies for the appropriate wire and terminal.
3.
Loosen the #8-32 setscrew in the upper tool holder in the hydraulic head assembly. Place the punch (Nest)
in the top tool holder and retighten the setscrew. See Figure 2.5.
4.
Loosen the #8-32 set screw in the lower tool holder in the hydraulic head assembly. Then, place the anvil
(Indentor) in the lower tool holder of the hydraulic head assembly and retighten the setscrew.
CAUTION:
A wrong combination of dies may cause critical damage to the tool.
2.4
Terminal Specifications and Crimping Operation
SCOPE
This tooling is designed to crimp Molex Imperium and Imperium Plus.
Imperium and Imperium Plus
Crimp Die Application Chart
Wire
Size
Wire
Finish
Wire Type
Conductor Diameter.range (mm)
Terminal
Order No.
►
Crimp Die
Order No.
Press
Order No.
1 AWG
Bare Copper
779 (strand)/30
(9.40 Max. Conductor Diameter)
171423-1401 19290-0100
19286-1000
Pre-Tinned
817 (strand)/30
(9.40 Max. Conductor Diameter)
171423-1401 19290-0100
Post-Tinned
779 (strand)/30
(9.40 Max. Conductor Diameter)
171423-1401 19290-0100
2/0
Bare Copper
1254 (strand)/30
(11.3 Max. Conductor Diameter)
171423-1201 19290-0350
19286-1000
Pre-Tinned
1330 (strand)/30
(12.50-11.35mm Diameter)
171423-1001 19290-0300
Post-Tinned
1254 (strand)/30
(12.50-11.35mm Diameter)
171423-1001 19290-0300
►
See the ATS Document for the proper Crimp Die.
