6.6 Tilting or Removing the Fluidics Module
6.6 Tilting or Removing the Fluidics Module
If you need to tilt or remove the fluidics module to clean up after a large spill, or to
recover tips, follow these instructions.
Warning!
The following procedures must be completed by a
service-trained
user. Do
not attempt the following procedures if you have not been trained properly by appropriate
Molecular Devices Personnel.
Warning!
Do not remove cover until power is disconnected. Do not operate instrument
unless all covers are in place.
Biohazard
:
This procedure includes steps involving potentially infectious biological
agents requiring that proper handling precautions be taken. Follow your institution’s
biohazard protocol.
actual˚C
set pt˚C
Set Temp
Temp
on/off
Drawers
reading
chamber
compounds
tip rack
Opening the Top Cover
FlexStation II Operator’s Manual – Rev. D
115
Summary of Contents for FlexStation II
