9
OPERATING INSTRUCTIONS
To reduce the risk of fire, personal
injury, and product damage due to
a short circuit, never immerse your tool, battery pack
or charger in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-
containing products, etc., can cause a short circuit.
If any parts are damaged or
missing, do not operate this
product until the parts are replaced.
Use of this
product with damaged or missing parts could result
in serious personal injury.
Do not attempt to modify this
IMPACT DRIVER WRENCH or
create accessories not recommended for use with
this IMPACT DRIVER WRENCH.
Any such alteration or
modification is misuse and could result in a
hazardous condition leading to possible serious
injury.
To prevent accidental starting that
could cause serious personal
injury, always remove the battery pack from the
IMPACT DRIVER WRENCH when assembling parts,
making adjustments, cleaning, or performing
maintenance.
This cordless IMPACT DRIVER WRENCH must be used
only with the battery packs and chargers listed
below:
Battery Pack Selection:
B201505MZ(L), B202005MZ(L), B202010MZ(L),
B203005MZ(L), B204005MZ(L), B204010MZ(L).
Charger Selection:
C05MZ1US, C10MZ1US, C20M1US, C20MK1US.
NOTICE:
Please refer to the battery and charger
manuals for detailed operating information.
FUEL GAUGE BATTERY PACKS
Some MOKENEYE battery packs include a fuel gauge
which consists of four green LED lights that indicate
the level of charge remaining in the battery pack.
The fuel gauge is an indication of approximate levels
of charge remaining in the battery pack according to
the following indicators:
To actuate the fuel gauge, press and hold the fuel
gauge button. A combination of the four green LED
lights will illuminate designating the level of charge
left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate
and the battery will need to be recharged.
NOTICE:
The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based on
product
components,
temperature
and
end-user application.
For more information regarding fuel gauge battery
packs, please send e-mail to Mokeneye Customer
Service: [email protected].
LED FUNCTIONS OF CHARGER
LED WILL BE ON TO INDICATE STATUS OF CHARGER
AND BATTERY PACK:
•
LED lights up red = Fast charging mode.
•
LED lights up green = Fully charged and in
maintenance charge mode.
•
LED lights up green = When an under-charged
battery pack is inserted into charger, indicates
hot battery pack or that battery pack is out of
normal temperature range or deeply discharged
or defective battery pack.
•
No LED on = Defective charger.
CHARGING THE BATTERY PACK
See Fig. 2
Battery packs for this tool are shipped in a low
charge condition to prevent possible problems.
Therefore, you should charge it until the green LED
on the front of the charger comes on.
CHARGING A COOL BATTERY PACK
If battery pack is within normal temperature range,
the red LED on charger will come on.
NOTICE:
If the charger does not charge the battery
pack under normal circumstances, return both the
battery pack and charger to your nearest Mokeneye
Authorized Service Center for electrical check.
•
Charge the battery pack only with the charger
provided.
•
Make sure the power supply is normal household
voltage,
110~240 volts, 50/60 Hz, AC only.
•
Connect the charger to the power supply.
•
For C10M1US charger, insert the plug of the
charger into the charging hole of the battery pack.
•
For C20M1US/C20MK1US charger, place the
battery pack in the charger aligning raised rib on
the battery pack with the groove in the charger.
•
Press down on the battery pack to be sure
contacts on the battery pack engage properly
with contacts in the charger.
•
Normally the red LED on charger will come on.
This indicates the charger is in fast charging mode.
•
Red LED should remain on for approximately 1 to
2 hours then the green LED will come on. Green
LED on indicates battery pack is fully charged and
charger is in maintenance charge mode.
NOTICE:
The green LED will remain on until the
75-100% charged
50-75% charged
25-50% charged
<25% charged
Pack needs to be charged
Summary of Contents for IM02Z
Page 14: ......