2. LOWER LIFT ONTO MECHANICAL LOCKS (ON 6
TH
OR 7
TH
LOCK POSITION). SECURE
DOWN HANDLE AT POWER UNIT IN LOWERING POSITION. (SEE BELOW)
3. PLACE CLAMP AROUND SIDE SUPPORT ARMS AS SHOWN.
ENSURE THAT CLAMP IS
SNUG
.
4. DISCONNECT HYDRAULIC LINE AT BOTTOM OF CYLINDER ROD.
5. CAP VELOCITY FUSE AT END OF CYLINDER ROD LOOSELY.
6. REMOVE SET SCREW AT END OF CYLINDER ROD.
7. PLACE RAGS OR PAPER TOWELD UNDER ROD END ON FLOOR.
8. USE CROW BAR TO PRY PIN OUT OF END OF SUPPORT PLATE AT CYLINDER ROD END.
(A SOCKET MAY BE HELPFUL TO SHIM THE PIN OUT OF THE HOLE).
